Dyno'd the baby II

Post by **jdmfreak** » Wed Feb 04, 2004 11:17 am

<<<<<<<<<<checked into a padded room.

Post by **fito** » Wed Feb 04, 2004 11:17 am

Sorry for the delay ladies, I promisse that I'll get the cable tommorrow!

Post by **jdmfreak** » Wed Feb 04, 2004 11:17 am

You betta!

Post by **rudeboy** » Wed Feb 04, 2004 11:17 am

<<<<<<<<<<chewed off last finger nail

Post by **93RPS13** » Wed Feb 04, 2004 11:17 am

<<<<<<<<<<<<gone to look at engine p0rn

Post by **jdmfreak** » Wed Feb 04, 2004 11:17 am

Engine p0rn where can I get some of that? Please tell me cuz I need something to do besides chew my arm until this guy posts up the vids.

Post by **93RPS13** » Wed Feb 04, 2004 11:17 am

anywhere and everwhere....haha

Post by **rbsileighty** » Wed Feb 04, 2004 11:17 am

fito wrote:rbsileighty

The setup is perfect for street use. The only thing is the exedy clutch is a BIT hard for daily use. You wouldn't notice the difference between a factory ECU RB25 and one with Microtec. I spend $250 on the dyno

What made you go with the LTX12 vs the LTX8 computer? Now that I got my motor for so little, a Microtec is definitely feasible.

Post by **JESTER** » Wed Feb 04, 2004 11:17 am

Had to jump on this one. WHERE IS THE VIDEO!!!! Dude, you are about to make half of NICO stroke out.

Post by **DETurbine** » Wed Feb 04, 2004 11:17 am

Is the head also stock?

Post by **BoostFab** » Wed Feb 04, 2004 11:17 am

rbsileighty wrote:What made you go with the LTX12 vs the LTX8 computer? Now that I got my motor for so little, a Microtec is definitely feasible.

the LTX8 is for 4 cylinders

Post by **WDRacing** » Wed Feb 04, 2004 11:17 am

I'm considering a life time Ban if I don't get to see the video soon.....

Post by **jdmfreak** » Wed Feb 04, 2004 11:17 am

WHERE THE HELL IS IT???

Post by **rbsileighty** » Wed Feb 04, 2004 11:17 am

BoostsFed wrote:the LTX8 is for 4 cylinders

"The MicroTech LTX-8 is a fuel and timing controller. It controls Air/Fuel, Timing, and up to 8 low impedance injectors or 16 high impedance injectors. This computer includes the modules."

I don't see why if it can control 16 injectors, and when there is a wiring diagram on Microtech's website for a 6cyl Nissan (http://www.microtechefi.com/mt_wiring.asp) it couldn't run a 6cyl motor. I do not have any experiance with this computer, so can you see where there would be confusion.

Post by **fito** » Wed Feb 04, 2004 11:17 am

Sorry for the delay guys. I got my other car (not the 240sx, Thank God) Robbed from my office parking this monday and I have been Doing paper work and stuff. I WILL go this Afternoon and get the cable. I PROMISE YOU WILL HAVE YOUR VID TONIGHT!again sorry for the delay. As soon as my insurance works everything out I'll buy a new car ( I'm thinkin G35, what you guys think?)

Post by **rey_boricua** » Wed Feb 04, 2004 11:17 am

fito wrote:Sorry for the delay guys. I got my other car (not the 240sx, Thank God) Robbed from my office parking this monday and I have been Doing paper work and stuff. I WILL go this Afternoon and get the cable. I PROMISE YOU WILL HAVE YOUR VID TONIGHT!again sorry for the delay. As soon as my insurance works everything out I'll buy a new car ( I'm thinkin G35, what you guys think?)

sorry about you car being robbed dam Puerto Ricans. I think you should get the G35 I think it's more pimp

Post by **rbsileighty** » Wed Feb 04, 2004 11:17 am

Sorry to hear you got robbed bud. G35 sounds like a nice replacement.

Here is the info I found from when I wrote Microtech about the LTX8 vs. LTX12:

"You can run an LT8 on a 6 cyl. You just use 3 injector drivers running 3 goups of 2 injectors.The main difference with this over the LTX12 is that the 12 will run the 6 cyl sequentially with 6 drivers .The 12 has some other nice features also but as the running of the injectors and ignition goes thats the only difference.Regards, Tim"

I will definitely go with the 12 for the ability to fire sequentially.

Post by **jdmfreak** » Wed Feb 04, 2004 11:17 am

Sorry bout the car. If ya dont mind me askin...What was the car that got stolen. The G would definately make a nice replacemant.

Post by **Wykid 240** » Wed Feb 04, 2004 11:17 am

Hey peeps, I'm new to the board. I was lookin and see that alot of you like the Microtech over, say, Power FC. . . why is that? Also, What clutch do you all recomend? Oh, one more thing. I'm in the market in a RB25DET front clip. Who would be the best place to buy one from?

Thanks,Jeramy

Post by **JustinStrife** » Wed Feb 04, 2004 11:17 am

Not to be an a-hole or anything, but there's a nice red button on the top right of the nico screen called SEARCH. It's your best friend.

Or msg some of the guys on AIM or whatever messenger they use. You'll get flamed alot less if u use the red button though. Think of it like the red vs blue pill...

Post by **fito** » Wed Feb 04, 2004 11:17 am

WELL GOT it, who's hosting?????

Post by **fito** » Wed Feb 04, 2004 11:17 am

I have, but it says (Invalid Format: The 'wmv' format is not accepted. Please upload JPEG images only)

Post by **fito** » Wed Feb 04, 2004 11:17 am

Yes, I have uploaded Mpegs but I dont know hoe to change the format on this video

Website · Post by **frosted flakes** » Wed Feb 04, 2004 11:17 am

dude i am so ready to see this video

Post by **fito** » Wed Feb 04, 2004 11:17 am

Let's see if this works

[IMG] http://briefcase.yahoo.com/fitomora69[/IMG] made a change try now

Post by **fito** » Wed Feb 04, 2004 11:17 am

YES, I think I got it. Please someone tell me if it's ok?

Post by **rbsileighty** » Wed Feb 04, 2004 11:17 am

nope... how big is the file?

Post by **USsil80** » Wed Feb 04, 2004 11:17 am

nosays he folder empty

Post by **JustinStrife** » Wed Feb 04, 2004 11:17 am

it says the folder is empty

Website · Post by **frosted flakes** » Wed Feb 04, 2004 11:17 am

its not working for me....

Dyno'd the baby II

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums