What was done to your 240 today?

[Dr.feelgood]

yesterday i put my new rims on konig villians got the whole set with good tires from a junkyard for $150 looked them up $150 per rim





and its getter lowered

[Rays240sx]

After a month I finally got a chance to install my HKS Exhaust for my S14
http://www.youtube.com/watch?v=fF4mGhu2p5Y

[nismoracingsx]

Bought a nismo power brace?
Jonnie's brace wouldn't quite line up for me to install (1/2 an inch off on one side?). Figured either brace is off or my brackets are :p, so I picked one up to try it out when I re-deploy

[98blackbell]

Tien tie rods, isis front support suspension- got rid of the clunk when tapping the brakes at lowlow speed. Put baffles on rack and pinion arms. Getting the car ligned up as we speak.

Next is LSD tires sunroof and rear suspension!

[lownslows14]

removed the turbo looking for the cause of smoke and little compression

[costa_rican13]

looked her picturing slammed on coils, then drove her for abit.

[93240guy]

Remove radiator, thermostat, water pump, head, and oil pan.

[nevertheless]

Popped the hood, and started it for my dads friend.

[S14toRPS13]

Car's been sitting for almost 2 years. Drained the fuel tank, filled up with fresh 92 octane, new fuel filter, change fluids, washed car, installed Nardi steering wheel, NRG steering wheel quick release, installed Alpine head unit, installed Alpine hu power pack, installed seats from Sonic Motor, installed new front turn singals lights, put in D Max floor mats, and installed Apexi power intake. Oh yeah, my bov was stuck so I took that apart and cleaned it up too. It seems to be working fine now. I think that was all I did, but there's probably more that I forgot about.

[-RJ-]

hmm, I put the top back up on the vert and watched my back window rip off

[Hijacker]

That sucks, RJ.

[kouki-gymkhana]

Finally installed my s13 silvia front end with aero bumper! I've had the parts since January and finally got around to it this past weekend. Had to do quite a bit of modification to the bumper support and front undertray because my stupid FMIC is sitting a bit low. I can't move it up without totally redoing the FMIC mounts and piping. Also started my silvia dual projector TSX HID retrofit!

[midnightouge]

I fixed my boost leaks.
It's fast once again.

[midgeman240]

i pulled out the manifold and tubo to replace my blown gasket. once i got it put back together my oil feed threads in the block stripped. i'm not sure what to do... headache number two commence.

[good2go_240]

248/232 cam swapped my vert. Quick free noticeable upgrade.. Defiantly recommend this on manual 240's

[Steady_One_S13]

I finished my 5 lug, Z32 caliper conversion. p.i.t.a

[JDM240SXcoupe]

I installed my new mishimoto radiator and thermostat and still overheats The lower radiator is not getting hot so im guessing my thermostat is not opening and its brand new grrrrr.

[bllabong89]

I had that same problem after I installed my mishimoto radiator. I hope its not something with the radiator because that put me over the top and made me start my complete overhaul.lol

[Michaelmoore]

Bought a new Knock sensor, Dash, and exhaust bolt.

[FlipCoupe]

tightened/cleaned all my grounds and ran a couple extras out of some old amp wiring.

Took off 4 bolts and 2 screws to the plate covering my fuel pump, Walbro should be here in a day or so..

hopefully that fixes my starting and immediately dying problem -.-

[breadbox]

hmm, I put the top back up on the vert and watched my back window rip off

Told you needed a new top. Hey this winter you want to try to make a hard top for your car?

I did an oil change.

[bmr.S13]

drove it to the junkyard and back

[hudy]

Installed a used diff I got off craigslist. Now I need an exhaust and some sway bar end links.

[wingFeather]

LED bulbs in the dash

[Hijacker]

hmm, I put the top back up on the vert and watched my back window rip off

Told you needed a new top. Hey this winter you want to try to make a hard top for your car?

I did an oil change.

Someone tried that a few years ago. I don't think it ever amounted to anything.

[speedeast]

1-piece stainless clutch line!

[SoCal-S13]

got out of the ER. woot!

[nevertheless]

Got my new tags and registration for her. only $6.50. I accidently lost them.
Need to find my oil leak and finish the break in.

[indomiekid1]

finally put on my mb battle wheels.(fake wheels = saving money, and i likes them.) um looks better. still need to do a small pull/roll, install ruca, change the tie rods,replace my destroyed ball joints up front.
and alignment. then maybe ill put my re-built motor together.
still got plenty to do.

[zerodameaon]

Went shopping for Coils and a new RB25. Sourced both for a good price. Just gotta continue to save money well on deployment.