Post by
Project13 »
https://forums.nicoclub.com/project13-u274199.html
Tue May 09, 2017 2:29 pm
Hey guys,
Im new to this forum, or any forum actually..
So I've been chipping away at getting my s13 up to standard. It was dented, spray painted, cable tied and knocking away. now though, New interior(seats, carpet, dash etc), Rb20det swap (wired up) and now getting her ready for paint.
Image
I am by no means a mechanic or anything even remotely similar but I thought I'd learn the old school way and just dive in. Most of the work on my car has been done by me and I would like to think I can clean up the last few steps too. As many people that have put an rb in an s13 will know, you struggle to close the bonnet with the standard intake manifold. This led me to going to a front facing plenum which is why I think I'm stumped at the moment.
I have had a good look around on this forum and also other sites for weeks trying to answer my own question but have come up empty handed.
My question to you is: What hose goes to this tee?
There is a tee joiner on top of the engine, between intake manifold and rocker cover. It is by the IACV & Cold Start.
Image
At the moment 1 port on this tee is plumbed to the IACV, the other is going to the cold start valve (the other side of the cold start is plumbed to the intercooler piping before the throttle), the third port is empty and I have no idea what to do with it.
Does it need to go to the intake manifold??
I feel like I should be able to figure this out so sorry in advance for any answers that seems glaringly obvious.
Hopefully somebody here will be able to shed some light.
Thanks guys.
P.S Hope my photos worked, They don't appear in the preview but then again I can never normally see pictures on this site... maybe a mac thing?
If I need to explain better let me know.