Do it the way OEM intended it to be- Cut out the small triangular shaped piece on the driver's side of the heating/cooling unit, epoxy in the aspirator plug, attatch hose to it then plug hose into the cabin air temp sensor. Attatch the cabin air temp sensor to your radio bezel surround so it can access cabin air.40daws wrote:Is everyone that has the aspirator hose using it and cutting the hole in the airbox ? Or just hooking up the cabin temp sensor onyl,no aspirator hose ?
You might be able to X-acto it, but i dremeled' mine. Goodluck40daws wrote:Thanks for the info Kevin ! How tough is the material of the airbox ? Exacto knife or will by kersaw knife do it ?
So it does move but only after it warms up? I haven't tried to get the blower to cycle thru the different speeds yet but it is working.iiymij wrote:needs time to warm up, does that with mine as well and i dont get the full different changes with each degree i change the temp until its been on for a while
argh did u get the blower to work properly?
Hey sorry i couldnt get pix here some from the last pageiiymij wrote:
From my harness i have part of the harness after that. You can see this B/R wire turns into a fat wire after?