All out on All motor...

[240nismo]

Ok i have been thinking of mods to do and still remain all motor...so far i have-JWT ECU-550cc Injectors-SX fuel pressure regulator-Nismo solid lifter valve train-polished valves-Port & polished (.60) head-Shotpeened rods-Nismo Racing cams-S&S headers-Race pipe-3" greddy exhaust with Apexi N1 muffler-6-puck clutch-11 lb JUN flywheel-K&N filtercharger with Hot Shot cold air induction-Unorthodox racing underdrive pulley-Jacobs electronics ignition amplifier, wires and coil.-100 shot of nitrous.-4 core aluminum radiator-upgraded alternator-11:1 Wiseco Pistons

im going to install electric fans and nismo motor mounts next

But im stumped with what else i can do and remain all motor and get more power. any ideas/suggestions/smart*ss comments? lolthanks

[TrunkMonkey]

-don't waste your time and money on 550cc injectors. you won't need them.

-jacobs electronics products suck ***. i've heard way too many people say it's not better than stock.

-a 4 core aluminum radiator is some serious overkill.

-11:1 compression with 100 shot of nitrous? i hope you know what your doing.

-demetrius

[240nismo]

i already have all of that stuff in my car bro... im wondering if theres anything left to do...and im swappin out the Jacobs for MSD i think.

[Toahk]

Could always get a good LSD to transfer that power to the ground better. Have your dyno'd the car with those mods?

[240nismo]

no after the pistons and rods and ECU but with the nitrous and everything else it was at 287.67rwhp...i wanna get atleast 300 with the nitrous--and with the pistons rods and ecu i'll be close...then im gettin the drive shaft from enjuku... Im pretty sure my ignition coil wasn't in the system when i dyno'd either, i could be mistaken though. I'm thinkin about that 5th gear set on Enjuku, what would that do? make me achieve top speed faster, or just increase my ability to get a higher top speed?

PS. all on an engine with 9k miles...just broken in:)

[drift-sx]

bigger shot of nos,reinforced internals

[240nismo]

More than a 100 shot?! Im not that brave! lol

[leper421]

A V8? WTF else is there?

[f8sjester]

since when is nitrous considered all-motor?

[240nismo]

does anybody have the HKS twin power coil? how is it if u do?

[240nismo]

Went to the Dyno last weekend... NO NITROUSWith the Ignition, Pistons, Rods, i messed with the timing a bit and worked out the vacuum kinks. On 100 octane and 72*F233.68 rwhp208.10 ft/lbsI don't know if i want to turbo it or leave it all motor right now, i might get another S13 and turbo it.

[TrunkMonkey]

maybe i'm missing something, but how the hell did you hit 233.68 rwhp with just those mods?

would you be able to post your dyno graph?

-demetrius

[toki]

More than a 100 shot?! Im not that brave! lol

I am going to be running a 200 or 250 shot on my KA with 9:1. Get some balls :P lol just kidding.

It sounds like you already have strong internals, I didn't read the whole list again, but some head work may be needed, but a 150 shot be no problem with the CORRECT OCTANE. If you don't feel like having to buy 100 all the time look into toluene and xylene.

Good luck

[soilwork240sx]

<~~~~~agrees with demetrious. im not buying it unless i see a dyno graph.

[jdmfreak]

Ditto.

[C-Kwik]

Which Jun Flywheel are you using? I can't find a listing for a KA application.

What RPM's are the peak HP and torque figures at. Or just post the dyno chart.

[Aries]

dyno graph please

BTW, you're torque numbers are low because your head isn't flowing enough. Time for a 5 angle valve job, and to squeaze in some larger (interleaved) valves.

[I am Technoman]

This would be the first motor that i have seen that made 200 +.

dyno please

[240nismo]

I don't have a scanner or i would, i'll see if i can use my ex-girlfriends. I've been workin on this car for about 4 years...put all my money into it, and it's almost done, i need the nismo motor mounts and i'll be done, i'm gettin ready to oder them through you Aries. What is the difference between the 3 angle, and 5 angle valve grind???

[I am Technoman]

240nismo if you really do make that much power with out no2. you have the most N/A hp KA in the US!

[240nismo]

no, there is a racing one that has 260rwhp. Nassports or something. But i still like to drive mine on the road Im goin over to my ex's i'll have it posted by toninght!

[I am Technoman]

I ment street.

[I am Technoman]

Are you still using an open diff?

[240nismo]

Yup...My mom told me to stay away from drugs, so LSD is not for me:)

[240nismo]

See if this attachment works...

[C-Kwik]

Can't see it.

And you didn't answer my question about the flywheel...

[TrunkMonkey]

i'm gonna do this now and get it over with...:bsflag

i'll be more than happy to pull it down when and if i see proof.

-demetrius

[240nismo]

I got it from either Nismoparts.com, or nissanmotorsports.com, or one of the nismo sites, i got it about 2-3 years ago tho, so i dunno if they still carry them. Oh and demetrius...when i figure out how to load my scanned Dyno sheet up, i hope your foot tastes good...

[jdmfreak]

LOL. I aint sayin that your lyin or any thing, but I have to see it to believe it just like everyone else

[240nismo]

Post your email addresses if you want me to send it to you...i can't post it here, its wiggin out.