Where do these plugs and hoses go??

For the RWD SR20DET cars! Sponsored by Wiring Specialties.
mugenrsx
Posts: 71
Joined: Tue May 01, 2007 5:41 pm

Post

i need help to figure out what these things go to??

first picture is the thing on the ignitor, i put a plug in there but the bottom looks like hoses go onto their but than i have like a broken thing, wondering do i need this??



This plug is on my main harness i plugged everything up except for this one and i dont know where it goes??



heres another picture of it



And this is a hose that runs on top of the transmission, and i followed it to here and i dont know where this goes.



mugenrsx
Posts: 71
Joined: Tue May 01, 2007 5:41 pm

Post

also on the lower harness i have to grounds right next to the alternator, i put the small 8 millimeter one in but i dont know where the bigger one goes.... any help?/

nzmoman
Posts: 2302
Joined: Mon May 22, 2006 2:27 pm
Car: 240sx 2 of em' and always lookin for more

Post

the first pic looks like your boost solenoid. You dont have to use that.

im not sure about the plug but it doesn't look like one I have every used.

also there are two lins to the alternator...one power one ground. There is big ground cable that goes to the intake manifold and there is the oil pressure line and the two lines to the starter and at least one other ground cable going to the chassis. Thats all I can remember from the S13 lower harness.

User avatar
IanS
Posts: 9758
Joined: Thu Dec 23, 2004 3:07 pm
Car: 2002 Subaru WRX, 2010 Subaru Forester XT, 2004 Infiniti G35 Coupe.
Location: Esko, MN
Contact:

Post

Is the whose attached to the transmission itself? If it is, it is just a vent for the transmission, it does not attache to anything, it just allows the case to breath.


Return to “SR20DET Forum (rear-drive)”