Specific measurements needed for S13 FRONT ball joint.

[KnifeForkDriver]

I am trying to find info on the S13 front ball joint. I need exact measurements of both the diameter of the base (the part that gets pressed into the LCA) and I need to know the height from the lower lip to where the snap ring attaches. Please refer to the linked photo for clarification. If you don't have a ball joint to measure, I could also go by the measurements of the bore on the LCA itself. Thanks in advance.

http://s34.photobucket.com/alb...t.jpg

[OM3GA]

Are you making some kind of extended ball joint or something so that you will correct the arms angle on a slammed car?

[KnifeForkDriver]

I am trying to use S13 application roll center adjusters. I think the fitment is close to what I need, but I would like measurements to verify.

[White Comet]

man, if you would have asked a few months ago i would have been able to give you all the measurements, but now everything is on the car

[KnifeForkDriver]

No worries. I'm sure someone here knows.

[KnifeForkDriver]

I suppose even measurements of an S14 ball joint would work. I know that besides the taper, they are interchangable with S13 front ball joints.

[IanS]

Why dont you wing down to the local parts store and ask to borrow one for a minute? Im sure they would let you measure one.

If you wait a week or two I can get the measurements for you.