should i do my brakes?

Post by **navysnail** » Thu Mar 11, 2004 5:38 pm

use heat, just a propane tourch and beat the living **** out of it from behind with the biggest hammer you can find. it will bend the rotor a little when you do it, thats how you know your doing it hard enough. persistance will get it, dont give up! hit it in the disk part=more leverage.

Post by **Kiwi_S13** » Thu Mar 11, 2004 5:38 pm

240kid wrote:use heat, just a propane tourch and beat the living **** out of it from behind with the biggest hammer you can find. it will bend the rotor a little when you do it, thats how you know your doing it hard enough. persistance will get it, dont give up! hit it in the disk part=more leverage.

Ha, from the 'kid' that said they would just pull off..

Post by **240SXedUp** » Thu Mar 11, 2004 5:38 pm

Doesn't 1/2 can liquid wrench + torch = big trouble?

Post by **Silent Drifter** » Thu Mar 11, 2004 5:38 pm

no not trouble just big ball of fire which is big fun.

Post by **nlzmo400r** » Thu Mar 11, 2004 5:38 pm

get some real grease to let that baby off of there. When i replaced all 4 of my pads/ bled hte lines about a week ago, it took no more than 3 hours for all of em, and my rotors were fallin off, i had ot tighten em back up

should i do my brakes?

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums