safc2

[hpmachine]

oops! yeah i assumed you had a z32 maf. that'll teach me to assume anything!! well... may be not

[nissans13240sx]

ok and how about the knock sensor how do i do that setup? the book says somthing about starting it up and some ****... thanks for all the help by the way i really appreciate it

forgot to ask what i put at the sensor CAL. screen? gives me the option of 1 in 1 out or 2 in and ADD out ???
Modified by nissans13240sx at 7:45 PM 8/31/2006

[sr20detmaybe]

im pretty sure that part is 1 in 1 out, i know on the knock thing u have to rev to a certain rpm, perhaps around 1700 and hold it there and push the toggle switch straight in and then rev to like ~3400 and hold it there and hit the toggle in again, itll tell u right in the manual how to do it but IIRC thats sort of how u do it.

[nissans13240sx]

thanks for the help im going to try to set the knocking sensor. i was reading it in the manual but it was getting kind of confusing, plus the fact that i cant stay focused for more then like2 minutes haha. thanks again

[nissans13240sx]

ok its done... after all thats haha... i just wanted to thank you guys for all the help i really appreciate it. just one more question off subject. im hooking up a air fuel ratio gauge to give me a rough idea of where im at. which wire from the o2 is the signal wire. i have a red white and blue wire. and do the red and black wires from the gauge get hooked up at the o2 as well or just to any power and ground? thanks again

[RPS13 DRIFTER]

is the wiring for the S AFC 2 the same for a NEO?

[Johnny JDMwerks]

hey hows it going.. ive been sitting here reading your whole convo about your safc and its funny cuz i got stuck with that same brown wire for the knock sensor too and i also have a few other questions.. if possible i would appriciate if you could give me a call at 916 225 9253 thankx - Johnny JDMwerks