Post by
Beancooker »
https://forums.nicoclub.com/beancooker-u42602.html
Sun Aug 03, 2008 5:49 am
Well, there was a sad turn of events spawned by impatience.
I started to sand with 60 grit. After an hour, I had barely broken through the candy color. So I went to Home Depot, and bought a "Rapid Strip" wheel for the angle grinder. (Cringes right?)
Being very careful, I start to strip the bottom 8 layers of paint that are left. All is going well, and it's stripping it right through the paint, and no deeper than the primer.
Then I notice styrofoam in the primer? At that point I realized that I stripped through all the paint, through the primer, into the fiberglass/Kevlar, and into the protective layer of foam.
Yes, I am a retarded window licker.
Cost of helmet; $120. Cost of paint and supplies; $35.
Cost of helmet that I originally wanted, that I was afraid to buy because the wife would be pissed at me spending money; $170.
Cost of replacement helmet that wife bought me; $170.
Ironic, isn't it.
To Mia for hooking me up with an awesome helmet. Normally $239. but they hadn't sold well, so they were discounted 30%