Butterfly solenoid connection?

[CakeEater]

This is starting to piss me off. haha

I can't for the life of me locate the connection for the secondary butterfly solenoid into the harness.

I'm talking about the actual electrical connection.

I've looked all over the harness but seem to not find it. The harness is untouched and had the secondary stuff hooked up and working in it's JDM host.

Any direction as where to look is much appreciated.

I feel like a noob again.....

[float_6969]

It's in the FAQ. zerothread/225309"- Solenoid is ground switched by ECU, pin 8 on the ECU. This means one wire to pin 8 on ECU and one to power (12V)."

[float_6969]

This may also help you.

[CakeEater]

Holy damn, thank you. haha

I looked over the pin-out on the ecu and read the entire page you linked but for some reason it just didn't register. It's been one of those days.

Edit: Just before the OP I realized after picking through the FSM on the ecu wiring for a while that I was looking at the euro FSM...doh!

Thanks again.
Modified by CakeEater at 6:37 PM 2/9/2010

[float_6969]

NP, glad to help.