Broken block thread

For the RWD SR20DET cars! Sponsored by Wiring Specialties.
Post Reply
austins240
Posts: 410
Joined: Wed Sep 03, 2003 1:28 pm
Car: 93 240SX HB, 89 Rolla GTS
Contact:
Contact austins240

Post

you can just have an AN fitting (Aluminum) welded to the block directly. then your lines attach to that. know a few guys that do that on the block for the oil system and to make pressurized coolant systems too. just make sure the welder is good (and probably have to have the motor out)

but you won't have to worry about it again.

Top
User avatar
sbird1
Posts: 6211
Joined: Sat Nov 05, 2005 8:47 am
Car: 2006 BMW 325i
Location: Savannah, GA

Post

I was wondering about that. If I still get leaks, that may be my answer. I wish Summit would hurry up and deliver my new fitting!
Top
Post Reply

Return to “SR20DET Forum (rear-drive)”

Search for Nissan stuff on ebay!
Find Your Forum!

 

NICOclub's Nissan forums and Infiniti forums and all affiliated sites are the property of HDS Holdings, Inc.
They are independent publications and are not affiliated with or endorsed by Nissan or Infiniti.

Information Copyright © 2000-2026 by NICOclub, all rights reserved. Material may not be copied or reprinted without written permission.

Privacy Policy