blow thru maf (pics) UPDATE

[foCk]

i like your front mount, where did you get it from and how much did you pay?

[krayton]

ebay. 300 something, cant remember

[300Plus]

OK I think I'm going with the blow through, with the stock RB25 series II MAF . I'll use epoxy and prep it. but now I'm trying to find the perfect location for it. I trust Jon P when he tells me I need 8 inches of straight before and after the MAF. I just don't know where I'm going to find it... I'm thinking of putting it on the cold side after the intercooler but I'm not sure I'll have room before it bends for the TB/intake

[Carl H]

OK I think I'm going with the blow through, with the stock RB25 series II MAF . I'll use epoxy and prep it. but now I'm trying to find the perfect location for it. I trust Jon P when he tells me I need 8 inches of straight before and after the MAF. I just don't know where I'm going to find it... I'm thinking of putting it on the cold side after the intercooler but I'm not sure I'll have room before it bends for the TB/intake

you do not need 8" of straight before the maf nor after it.you should have atleast 4" before the maf but on my setup it goes right into a complex bend after the maf and ive had no problems with it so far.

[300Plus]

Awesome! glad to here it. My plan is to put it on the cold pipe on the straight section on the way up to the throttle body from the intercooler

[rb240det]

My blow through is right after a 90 degree bend and I haven't had any sort of issue with it. It's on the cold side about 8 inches from the last bend to the throttle body.

[side waz]

Hey man VERY clean work and I'm happy it's working out for ya!

Do you think this same set up would work on an RB20det motor?