Are these good numbers????????

[AZ89two4Tsx]

Hey guys. About 10 minutes ago I did a compression test on my SOHC and was wondering if these were decent numbers.

1- 125 2- 123 3- 122 4- 126

I was thinking about turboing it within maybe a year or more. How are these numbers, and if they're low, can you give me suggestions to make them better.

[BMAR240SX]

zerothread/226410

WD says 155 on each one is good

[AZ89two4Tsx]

I just read my chilton's maunal and figured out that we did it wrong. I didn't warm up the engine. It has only 60K on the rebuild so it should be fine. Oh well rookie mistake, (my first compression test) I'll do the test again and post the numbers.

[BMAR240SX]

Hey how did the transmission mount go?

[AZ89two4Tsx]

We haven't gotten to it yet because we're probably going to have to pull out the transmission and rebuild it cause it's pretty worn. And now it looks like we might have to pull the motor and rebuild it too. Kinda weird because the previous owner said it had 60K on the rebuild, but the rebuild was from the owner before him. Who knows. Anyways, it's not that bad because we were thinking of going KAE-T, so at least we can do it right. Just in case you wondering, I did the compression test agian and the numbers were around 135 all around (give or take around 3).

[BMAR240SX]

I have to do all that stuff myself also, goodluck tho i would definately like to see you go KA-T try and do some type of write up or so, or take lots of pic's. Goodluck man

[jspec603]

When your doing your test, are you holding the throttle wide open when cranking? If your not you will not allow the proper amount of air to get into the cylinder, thus the out-come will be an incorrect number.

[AZ89two4Tsx]

********************************!!! I read that in the stupid manual and forgot to do it!. ********!! Oh well, gives me something to do today. Btw, do you think the numbers would come out higher or lower?