92 stocker ka24det set-up

[rhtuners]

o.k. so this i pretty much my question on my set up. I have been reading alot before i even decieded to post this. i am using a t/3 turbo and will be running on stock internals with the addition of stage 3 clucth cosmetic head gasket turbo timer apexi safc, and walbro 255 fuel pump. i want to know if sr20 370 injectors are good enough for me to use on my stock fuel rail. i am only looking for 250hp. so far what i have read it is a realistic number for stock internals. can anyone comfirm this??

[clss240]

yeah the 370s with a tune should be just fine with what you explained.

[eazye2000]

I think 250whp is pushing those injectors to their limit.. I'm not sure though.

But everything else sounds about right. You should be able to get at least 200 out of that setup.

[rhtuners]

o.k so the other thing is am i fine running the stock maf or should i swap it for z32 maf or should i use the sr20 maf??

[rhtuners]

i beleive i should be fine since i am only going to be running 8psi. i am looking for a daily driver and realiability

[clss240]

the maf has been tested for up to around 9 psi out of a 60 trim t3/t4 i believe.

[WDRacing]

Might wanna read the write-up that's stuck to the top of this forum.

zerothread/226410

[rhtuners]

yeah thanks for redirecting me to that post but that was not my question. But anyway thanks for everones help in answering my question. i can either run my stock maf or just run the z32 maf cause it can handle way more than what i want for HP. I spoke jason from Eformance LLC and i will be getting a tune from him. will keep everyone posted on progress