z32 MC problems

[bimeur]

Hi guys,

I bought a Z32 MC to put on my silvia.

But when i wanted to bleed, the front circuit is OK, and the rear has no pressure.

actually, it's on my 240sx with ABS, so only 2holes are used on the MC.

I wanted to open it to see if the MC's circuit got a problem, pull of the cap at the back of it (mastervac side), but i can't take the piston out, why?

I unscrewed the bolt at the front side, nothing better, did I mess something?

Is there a clip hidden somewhere?

THX for your help.

[MaximA32]

Did you bench bleed the master cylinder prior to install?

[bimeur]

Yep, it was done, but there's no pressure on the rear circuit, so I think that its' blocked..... :/

That's why I was asking about opening the MC

[MaximA32]

I'm gonna move this over to the 240 tech area as they're going to have a better idea of what's going on for you.

[bimeur]

THX

[bimeur]

Well, finally i found how to open it, and refurb it.

Thanks for your help