would this still be ok to use, look plz??

[Beemen550]

HAHAHAHAAHAHHA

sorry i just had to get a good laugh out of this, found this in my garage while i was finishing my sr20 install.

it was out of my old ka

[danb8586]

jb weld it together and yull be fine

[teddy]

I dont see anything wrong

[sunnys14]

bending the rod makes it rev faster

[92droptop]

JB Weld? pffffft...all you need is some duct tape.

[wild_maxx]

so thats the reason you went sr?

[PencilShavings]

rods only need replacement when theyre broken in half

EDIT: i see it is broken, im sure itll still work find though. as far as breaking things in half goes, yours isnt that bad.

[driftMachine]

LOL, too funny. That should be fine. I say JB it and put it back in the engine. A few miles of spirited driving should straighten it out good as new.

Or you could put it on ebay and say it's JDM, should get a few bids.

[Maverick7687]

LOL, too funny. That should be fine. I say JB it and put it back in the engine. A few miles of spirited driving should straighten it out good as new.

Or you could put it on ebay and say it's JDM, should get a few bids.

To hell with JB.. Put it on ebay as is and sell it as a new 2pc. set-up.. JDM of course...

[180sx]

weight reduced rod! u can now rev to 12000rpm

[teddy]

weight reduced rod! u can now rev to 12000rpm

pfft. Who needs rods. Run without em.

[WDRacing]

Jesus

That is the best way to lower the compression for more boost I've ever seen.

For the record, selling it on EBAY as a two piece JDM rod assembly made me pea my pants a little

WD

[Iamjohnhayes]

bending the rod makes it rev faster

Hell a shorter stroke will let you rev higher. that might even out rev the 13b that me and my brother are building for his 88 vert.

[BlackHat]

Make it a shifter!! would kinda be a pita to do, but would be cool!

[MS180SX]

how much power were you pushing to do that?

[Beemen550]

Make it a shifter!! would kinda be a pita to do, but would be cool!

haha, u can have it, if u make a shifter out of it

[Beemen550]

how much power were you pushing to do that?

not enough, it was a damn near stock sohc, someone neglected to keep up the maintenance on it before i bought it, shortly after it began knockin so i just beat the hell out of it until it blew up, put a softball size hole in the block

[get_up_mark]

as far as i know...rods are strictly optional anyway

[Maverick7687]

Man, I'm tellin you.. eBay.. JDM 2pc. Rod assembly.. It WILL work... Plus I want to see that ad...

[srdrps13]

lol... christ... looked like you had some fun with that motor

[MikeMurphy]

You shouldnt have those emission devices in there anyways.

[jrb92se]

i say go the ebay jdm route; but jb weld or duct tape it first then say its from a skyline