Will this Strut braces be fine?

[Luke]

I'm looking at these on Ebay, it's a front and rear set and it's cheap. Definately what i need, but im not sure about how they mount, they're different from the typical round 3-hole mounts. They're only like 2, i would believe that they would be just as good, but im not sure. They're made by a company called "Matrix" Anyone have opinions?

[lateralmotion]

the one on the top looks to be the rear, and it only has to have 2 mounting holes, cause there are only 2 in the rear, and the other on the bottom only goes on 2 out of 3, so i would assume it's not as strong, but i don't know, maybe there's someone else out here that has some similar ones. from what i know matrix isn't that bad, kinda ricey, not close to apc though. but a strut bar is essentially a strut bar, unless of course the mounting hardware bends or breaks

[WAbernethy]

That's probably not the actual one you'll get. I got mine off e-bay and I believe the picture was similar to that, actually it was made by the same company. So, I guess you'll get the same one I did, with 3 holes. I actually had to bend mine at the ends to get it to clear the valve cover. Not the best quality for sure but what do you expect for 20 bucks? Looks nice anyway.