Where to get parts for a 240sx

[tallicagolf]

Im looking for new pintle caps for my injectors as well as both o rings the smaller ones towards the tip and the larger one tawards the top, im not to familar with nissans, all i have ever owned were vw's so i don't know where to order parts, if some one could direct me to a place where i could i order these parts it would be great thanks

[Kenrik]

Advance autoparts... Autozone, Bennit auto parts... NAPA auto parts.. Pepboys... (yuck hate them) the list goes on... they should al be able to get you your O rings etc.. depends on which ones you have near you.. I got mine from Advance when I had an injector leak.

[1991S13]

Make sure you check the forum sponsors too (all the banners that come up around the page). I think on the 240sx.org page they are all listed there. A lot of things from them are cheaper than the neighborhood parts store.

[tallicagolf]

I actually i already went to autozone and the o rings that they had, only the small ones were a lot thinner than the stock ones that why i didn't put them on yet.

Anyone know where to get pintle caps?

[Kenrik]

Autozone usually does not have as many parts.. I usually buy from bennitt but you might not have one of those... (I think they are only in FL and GA) Advance autoparts usually has more selection or NAPA.. also you can use one of the ads on this site.. but you will have to wait for shipping.. as far as the O rings go.. there are smaller ones that go on the bottom of the injectors and larger ones for the top...

[sunnys14]

dealer... those o-rings shouldnt cost much

[tallicagolf]

Just got some from the dealer but now i think one of my injectors is stuck open so im gonna have them flow tested. any recomandations?

[240Titan]

Yeah check your local places, checker, autozone, pep-boys... they should carry them, the ka engine isnt parts specific since they use it in other nissans, unlike otherthings that only come on the 240

[newboyspo]

I just had all four of my injecters serviced by a local shop (90 ka24e) for $25.0 each, made a world of diff.. I also bought the injecter seal set (1 o-ring, upper insilator and lower insilator) fro napa, cost me like $4.60 for each kit..

make sure before you slide the injecter into the fuel rail that you use somthing to lube the o-ring or it might tear (and leak) fuel + Heat = poof!

newboyspo