I cannot locate my In-cabin Microfilter but when I took my Quest for 24000km service, my dealer ask if I like to have the filter replace, which I declined.
I was reading somewhere that some of the Quest owners didn't have the microfilter and was installed by the dealer after they found out that it was missing.
Is there a picture showing where the micro filter is? Thanks
where is the 2007 Quest iin-cabin Microfilter?
-
ricebike
- Posts: 3381
- Joined: Sat Feb 15, 2003 7:03 pm
- Car: 1989 240sx se 5spd (donated to my brother in law)
2002 Quest
2005 Altima - Location: CNJ
Re: where is the 2007 Quest iin-cabin Microfilter? (jc79c)
goto the following link:
http://www.nicoclub.com/FSM/quest/2007_Quest/
download the pdf file called "ma.pdf" to your desktop
open the file w/ acrobat reader
goto page 23 and the info w/ the instructions are thurr!
edit: it says to remove the glovebox assembly as your 1st step: so you may have to download "IP.pdf" as well to do that as well
http://www.nicoclub.com/FSM/quest/2007_Quest/
download the pdf file called "ma.pdf" to your desktop
open the file w/ acrobat reader
goto page 23 and the info w/ the instructions are thurr!
edit: it says to remove the glovebox assembly as your 1st step: so you may have to download "IP.pdf" as well to do that as well
-
Promise Land
- Posts: 1828
- Joined: Tue Mar 10, 2009 6:52 am
- Car: 2011 Nissan Versa
2001 Chevy Suburban
1992 Ford Mustang - Location: Sprague River, OR
- Contact:
Re: where is the 2007 Quest iin-cabin Microfilter? (jc79c)
Take the glovebox out (3 screws on bottom, 2 on top). Be careful to not let the G/B hang from the lamp harness. Behind that there is a small cover with 3 screws. Take it off and the filters are right there. There should be 2 of them according to the Service manual. Install is reverse of taking it off.
Re: where is the 2007 Quest iin-cabin Microfilter? (Promise Land)
Thanks guys. I removed the 3 screws and the cover but can't see the filters. Are the filters fitted on the the side? I can feel something on the side towards the back of the van.
I was wondering if I was looking at the right thing, so I started the car and turn the fan blower on and lots of air was coming out of the vent cover hole. But can't see any filters.
Modified by jc79c at 2:14 PM 4/7/2009
I was wondering if I was looking at the right thing, so I started the car and turn the fan blower on and lots of air was coming out of the vent cover hole. But can't see any filters.
Modified by jc79c at 2:14 PM 4/7/2009
-
Promise Land
- Posts: 1828
- Joined: Tue Mar 10, 2009 6:52 am
- Car: 2011 Nissan Versa
2001 Chevy Suburban
1992 Ford Mustang - Location: Sprague River, OR
- Contact:
Re: where is the 2007 Quest iin-cabin Microfilter? (jc79c)
maybe you don't have the filters in there then.
Re: where is the 2007 Quest iin-cabin Microfilter? (Promise Land)
Thanks again, I think you must be correct.Promise Land wrote:maybe you don't have the filters in there then.
So is it safe to say that as soon as I remove the cover (btw, I know its the right cover because it indicates the direction of the airflow) I should see the filters in the openning? Also Is the 2 filters stack one on top of the other lenghtwise?
I can feel something in front of the blower but can't see what it is, is this the heater core?
Modified by jc79c at 12:29 PM 4/8/2009