Where can i buy greddy s13 intercooler piping without the intercooler?

[turboex]

I just need the piping, and thats it. i have a good size front mount but i dont wanna have to do custom piping, any ideas?

[[GoaTSLonG]]

i was wondering the same thing.

[goldollar]

i dont think you can, that just one of those items that people luck out on every once and a while

[turboex]

ah ****ty i really dont wanna have to make mine. one of the nissasn shops need to come up with some universal piping. Its jsut that cold pipr with the deal for the IAC hose on it thats reallly getting me

[goldollar]

oh my bad man i real didnt read the titile of your thread, i tought you were talking about a stock side mount. I can say and do stupid things at times, i really dont know about front mount piping either, i would think you would have to get those made. but then again you could probly contact greedy and see if they have the piping. but it probly wont be cheap

[Nils]

I just need the piping, and thats it. i have a good size front mount but i dont wanna have to do custom piping, any ideas?

I was in the same boat as you... I think custom piping is the only way to go unless you are lucky and find someone who is selling used IC pipes.

good luck.

n

[turboex]

it jsut that all front mounts are about in the same location, and even if it was off a bit it would be easy to cut the piping a bit. Its weird that heavy throttle or someone does not make it yet. How much did you custom piping cost? any pics?

[Nils]

it jsut that all front mounts are about in the same location, and even if it was off a bit it would be easy to cut the piping a bit. Its weird that heavy throttle or someone does not make it yet. How much did you custom piping cost? any pics?

$200.00

here are some pics

n

[ImportIntelligence]

We sell all the mandrel bent pieces for the piping. It's T304 Stainless. We use this becuse it is easy to weld rather than aluminum. I run this IC pipe on my car and the pipes stay really cold after a good run. Is your IC a center feed, top feed or bottom feed? http://www.ImportIntelligece.com > Performance parts section > IC piping