Picked up a set of these at Walmart last night for 19 bucks. They had 3 in stock. Worked on it for 2 hours last night and finished the wiring this morning. I shoved them into the fog light holder behind the plastic cover for now. It looks pretty good other than the gap between the light and the hole. I did get some epoxy so I might do what you did but then I have no way to adjust them. I may build a metal extension on the back of the fog lights that I can bend at the back end and bolt it in the factory hole made for OEM lights. That would at least give me some metal I could bend to adjust the light angles.
The light color matches the head lights. Ok maybe they are a tad bit brighter when you stare at them.
My set had the same box and everything. The power wire already had a fuse on it. So, I just put the power wire into the live side of the Accessory Fuse and pushed the fuse back in.
How do you pop out the unused switch panel next to the mirror controls, push it out from the inside?
I wish someone would have answered this question. I had a tough time. There are 2 clips. One on the top and one on the bottom. Use a screwdriver to push it up on the top and down on the bottom. So, I could see that but I kept trying to push it out from the inside. I got mad and just forced it out with a screwdriver! Yeah real smooth!
But, no. You push from the outside in while you have a clip(s) raised.
Make sure you take your fuse cover and the side cover off so you can see it good.
After I got it out and cut it to put the switch in I was baffled at how I forced it out. It is so much bigger than the hole!