vh45de ITB's

[scir16v]

Did you guys happen to see this????

http://www.kinsler.com/page--Nissan--20.html

[Aus450zx]

Pretty sure it's been mentioned before because I have that pic in my "intake" folderAny idea on cost?

[scir16v]

Found out about this setup. Called Kinsler and asked about height, price and if the fuel rails came with it. The throttle bodies are 1.765 in in diameter. The intake can handle up to 450 hp NA. The intake height without horns is 5 1/2 in, and with the horns is 8 1/2 in. The cost with fuel rails is $4099. ouch.

[flyingbrick]

if you break the cost down its not that bad. Look at it per intake runner and its just 500$. for one throttle body, linkages, runner, trumpet and part of the fuel rail

[IThaJ0kaI]

You can get some sport bike ITBs, run those and save like 3099$.

[theramz]

Check these guys out www.extrudabody.com

[klh6686]

You can get some sport bike ITBs, run those and save like 3099$.

This is my plan, just trying to figure out if I want to go map based standalone or fab a plenum to allow the usage of a maf still.

[flyingbrick]

i vote plenum mate. Means you have an easier time tuning and you also get to use a propper air filter (easier)

[chharith]

Check these guys out http://www.extrudabody.com

those look amazing, I was too intimidated to call and ask for a price.

but I think the sport bike throttle bodies might be a cheaper resolution.

[brainfood]

Yeah I emailed them about price too and was like Rather fab something up from OE throttles.