Upgrading to Z32 Circut Sports rotors and Project Mu B-Force Pads.....

[xrproto07]

and i couldn't get the dam circut sports rotors that I ordered from phase2motortrend for my S14 on I mean I have been rolling on the stock Z32 rotors, conversion lines and duralast brake pads for about six months and recently decided to upgrade to the drilled and slotted circut sports rotors and Project Mu B-Force brake pads, and today when I tried to swap over to this new set the rotor wasn't clearing the caliper.... I ordered the 26mm rotors for the aluminum Z32 calipers and they just seemed to not fall right into place as if they were two big for the Z32 calipers . They should bolt right in and they don't.... is it possible that phase2motortrend sent me 30mm rotors instead of the 26mm?Can anyone chip in their opinion and what could be the problem?

[94_240sx]

Did you use a clamp wrench and push the pistons in? How much clearance are you talking about? A couple mms?

[xrproto07]

Well to be honest I didn't because there wasn't left to clamp down, I will clamp it down tommorow and see I that gives me the rotor flush enough to bolt the z caliper down. One thing that I did notice was that the rotor wasn't centered with the caliper so I hope it's just the pistons needin to be pushed in