Turning over to its grave?

ONLY for ADVANCED technical discussion about the 240sx!
junjun0134x
Posts: 27
Joined: Mon May 21, 2007 4:09 pm
Car: 93 Nissan 240sx
Location: Jacksonville, FL

Post

alright tonight i had to get a ride home from work cuz my car wouldnt start...i have a 93 with a ka24de...it turns over but doesnt start iv checked to distibutor cap and ign. pack both working fine and im not 100% sure but my fuel pump is working....iv had this problem for a few days where it would start but be spuddering kinda like its misfireing then start ideling fine after a few seconds and if it didnt it would spudder and just die and after that it would just turn over but not start for a while intill it decided to start later after a few tries... tom. morning im going bck to check it a lil better in the daylight so i can friggin see..but im still noobish and i was wondering if maybe yall can help me figure out whats wrong or tell me what i should check or watever to solve this prob..... i would greatly appreciate the help thanx


junjun0134x
Posts: 27
Joined: Mon May 21, 2007 4:09 pm
Car: 93 Nissan 240sx
Location: Jacksonville, FL

Post

even though i havent gotten any suggestions i finally got it to start and hasnt left me walking but the start up problem continues and it idles a lil funny and stalls a lil bit at take off somretimes

Rucca
Posts: 223
Joined: Thu Jul 19, 2007 4:10 am

Post

Check for codes yet?

junjun0134x
Posts: 27
Joined: Mon May 21, 2007 4:09 pm
Car: 93 Nissan 240sx
Location: Jacksonville, FL

Post

wow i feel stupid i should have checked a while ago..i just did it and got 12,13,14 which is

12 - Mass Air Flow Meter Sensor

13 - Coolant Temperature sensor circuit

14 - Vehicle Speed Sensor signal circuit is open

im pretty sure 14 is because of my removal of the top speed limiter (that thing was annoying ) and 12 will prolly explain my problem

thanx

Rucca
Posts: 223
Joined: Thu Jul 19, 2007 4:10 am

Post

Coolant temp sensor will make it run crappy too, check that out. May just be loose connection, the connection on the CTS can get pretty loose. Definitely check your MAF though.


Return to “240SX Technical Forum”