Throw out bearing problem

Post by **ajolliff** » Thu Sep 04, 2008 5:23 pm

Okay so I have a 91 240 hatch with an sr20det redtop in it with a spec stage three clutch. Well I never used the TOB Spec sent me. I went to autozone and just bought a factory replacement. Do you guys have any experience with this? The Spec TOB just didn't look like the the stock one at all. So after two "oem" TOB's, my car is parked once again and I apprerciate any opions other than the usual, "spec sucks!'. ha. Thanks a lot guys!

Andy

Post by **martins_240sx** » Thu Sep 04, 2008 6:39 pm

factory replacement? from autozone? which car did you say it was for?

Post by **ajolliff** » Fri Sep 05, 2008 9:27 am

Yeah I bought the TOB from autozone. But the car is a 1991 240sx with a redtop sr20det.

Post by **martins_240sx** » Fri Sep 05, 2008 6:53 pm

what car did you say it was for. because if you said it was for 240 then you have one for a ka not an sr

Throw out bearing problem

Throw out bearing problem

Re: Throw out bearing problem (ajolliff)

Re: (ajolliff)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums