throttle cable bracket

[silva180sx1515]

i was wondering if anyone had had to make a custom throttle cable bracket? My bracket won't work so i'm just trying to get some ideas. thanks

[rudee023]

I got one from an SR20DE at the junkyard.

[ColumbusDrift]

i think that you can use the ka one if you are still using the ka throttle cable, only one bolt will line up, and you might have to bend it a bit as this is what i did when doing a buddy's conversion

[sms240sx]

I just took the wiring harness support bracket off the firewall( the bracket has an L shape an has a hole on both sides) and I cut a section out with a grinder for the throttle cable to slide in. Its just the right length.

[rudee023]

SR20DE is a direct replacement. No fuss, no muss.

[MadSideways]

I had to make my own when I upgraded to the greddy plenum.

First I made a mockup with a piece of cardboard.

Then I simply took a sheet of aluminium cut out a template i made with card board.

Then I bent it in a 90 degree angle, and cut out two notches for the throttle cables, (2nd is for cruise control), and drilled 2 holes for the bolts.

Really simple actually.

[thes14project]

I had to make my own with my s13sr -> 98' 240 swap. I used some washers, nuts, and wire.