taking off spoiler

[hadokenny]

I am planning to take off the spoiler from my 95 240sx se. As far as i understand, there are two holes under the spoiler rite? So after i remove the spoiler, what are some ways to get rid of those 2 holes?

[89240sx]

bodyshop

[nissanrcer240]

i took my spoiler off my 91 hatch and there were like 10 holes?? the ones that had the screws in them had nothin in them(of course) but the other ones had plastic shiz all in them:rolleyes

[[Zero-S]]

Bondo if you want to leave it w/gray spots, or take it to a bodyshop. Personal rec. bodyshop.

[Atl_240sx]

Go to a GOOD body shop...get it professionally done

[hadokenny]

ok thanx for replies. i guess i will take it to the body shop to get it done. hoepfully it wont cost too much

[89240sx]

it wont be cheap!

they also have to match the paint

[AunVoh]

i did the same to my car, along with the antanne and badges =) just use bonda, and sand it smooth, then get some touch up paint from nissan, light coats along with 2000000 grit sandpaper and your set, it doesn't look to bad...

[stretch240sx]

if your good with welding you could always weld over them.... but the you wouldnt be asking this question...

[rousie13]

Thats what we did with mine. My uncle helped me weld over the holes, and it turned out very nice if I may say so myself.

[Queamore]

Welding is the best route to go but if you can't do that My friend who is a body man uses this stuff called tigerclaw it's supposed to prevent rust from forming after you paint over it. and works like bondo.

[f8sjester]

where do you get 2000000 grit sandpaper and how much does it cost?

[stretch240sx]

exxxxaaaaaggggerrrrraaaattion

[Altiman94]

take it somewhere, don't slouch on your vehicle's looks

[y3llows14]

Its not that hard man...you can either weld it or use fiberglass and patch it up. I went with the fiberglass route and it was pretty easy. My friend spot weld it shut but it was kinda wavy.