swirl pot install rb20 need help asap

[Gavin Johnson]

ok, i installed a greddy swirl pot on my car, top hose going to rad overflow nipple, next one down is capped, next one below that goes to overlow bottle, and bottom one goes to lower rad hose. my question is does the capped one HAVE to be attatched to a bleeder? if so where is this bleeder or do you need to tap a hole? and also does the tank have to be higher than the engine/ radiator? thanks for any input... also i searched but didnt find my answers thanks all

[DeformityX]

zer...-hooo its got everything you should need.

As per the mounting... yes it should be mounted as high as possible (Air always goes to the highest point of the system)

[Gavin Johnson]

yea thats the one i found when i searched, he just says braided line that goes to my head, which im assuming he means the one im asking about, just no idea where on the head he put it

[USMCgetsome]

you should only have to run 3 lines the fourth was an option for other vehicles. Cap it off.

[Gavin Johnson]

did that. and raised it up a little higher, seems to be working great now. thanks everyone!

[USMCgetsome]

post up your install pics on the radiator breather thread!