STOCK S14 SR20 Swap

[Somalie187]

I would like to know if you can take the whole harness within a front clip and just swap that out to put a full on stock engine swap from an S14 SR20 into well another S14

I want the whole engine to look as if it belongs in the car stock (COPS ;-)

Dont tell me to go and search answering the question is much easier!!!

I want it to look like...

http://sr20store.com/clips/Dsc00173.jpg
Modified by Somalie187 at 8:38 AM 12/11/2007

[jr_ss]

Search... The reason you can't just swap the harness in is because in Jap land the ecu was on our driver's side... Need to have harness lengthened and repinned on the F1 connector..

[duffman1278]

^^^Bingo

[Somalie187]

Why not just relocate the ecu with in where the current fuse panel is.

Or can a harness (male or female) be made to just connect and extend so that it may be on the passanger side of the vehicle instead of having to cut than lengthen?

[BoBa524]

Why not just relocate the ecu with in where the current fuse panel is.

Or can a harness (male or female) be made to just connect and extend so that it may be on the passanger side of the vehicle instead of having to cut than lengthen?

lol dude i jst did this swap, wtf u talking bout?

[Somalie187]

What are you talking about.

Me I am talking about keeping the cutting and hacking down to the absolute minimum.

Explain to me the minimum wiring involved to do this swap.

[bgsr240]

I'm not trying to be a d**k here but have you looked at just how many wires and other stuff are jammed under the drivers side kick panel? Just the thought of lenghtening all those wire and stuff makes makes me want to put a gun to my head lol.

Whats wrong with putting the ecu were its supposed to be? You only have to lengthen 3 wires.