Sr20 510 wiring question

Discussion forum for the venerable 510, and its non-US counterparts, the Datsun 1600 and Bluebird.
User avatar
Socrates
Posts: 17
Joined: Thu May 19, 2005 1:59 pm
Car: 1990 Nissan 240sx

Post

I have been searching for days and have not found any information on what exact wiring mods need to be done on the Datsun 510 inoder to get the Sr20 running. I have found many good sites with info on what is needed to get the engine in but as far as wiring goes I have had no luck. I am planning the swap for the near future and am just gathering as much information as possible.

I would really appreciate the help

thanks in advance


User avatar
datsunboy
Posts: 518
Joined: Mon Mar 29, 2004 3:14 am
Car: Datsuns
Contact:

Post

all you need is a "pinout diagram".this will tell you waht each wire coming out of the ECU goes to.....then just hook up your power wires

Turbo 510
Posts: 129
Joined: Thu Jan 02, 2003 10:45 am

Post

Get the factory service manual for a DE powered 240SX. The wiring for an SR is very close (exactly the same if you are using a 240 ECU). Eliminate the stuff you don't need and shorten the harness to fit into the 510 engine compartment.

User avatar
datsunboy
Posts: 518
Joined: Mon Mar 29, 2004 3:14 am
Car: Datsuns
Contact:

Post

if your going to get a service manual....then why not just get one for a SR20 200SX?you can download them free off the net


Return to “Datsun 510 / Bluebird”