SR and KA exhaust question

[sedoken]

OK i'm pretty sure this has been asked several times before but earlier today i used several words and phrases and couldn't come up with what i wanted.

anyways, first off i'm talking about cat-back exhaust. not headers/downpipe ect. just the catback part. and my question is, does a SR20 catback fit with a KA24 catback?

I have a 95 with stock exhaust so far. and i was looking at the fujitsubo power getter system. but it was for a SR motor.

honestly i don't see why it wouldn't fit. but does anyone know anyhting about it?

link to the exhaust below

http://www.ravspeconline.com/s...d=361

[adrianfromthecastle]

i'm not too possitive, but i dont think it will fit due to certain reasons, 1) sr exausts are usually intended for 3" while ka is 2.5" so it kinda depends on your cat2) the length of a downpipe might be longer than the length of the headers of a kalike i said again, i'm not too completely sure, i'm just guessing, but if you really wanna put it on, take it to a muffler shop and i'm sure they can do something for you to put it on.

[LayNLow240]

OK i'm pretty sure this has been asked several times before but earlier today i used several words and phrases and couldn't come up with what i wanted.

anyways, first off i'm talking about cat-back exhaust. not headers/downpipe ect. just the catback part. and my question is, does a SR20 catback fit with a KA24 catback?

I have a 95 with stock exhaust so far. and i was looking at the fujitsubo power getter system. but it was for a SR motor.

honestly i don't see why it wouldn't fit. but does anyone know anyhting about it?

link to the exhaust below

http://www.ravspeconline.com/s...d=361

exhausts are chassis specific, not engine specific. just get an exhaust for S14 and itll work with whatever engine you get. doesnt matter if you have a ca, ka, or sr. itll work with all of them. just be sure to get big enough piping if you have or are going to get a turbo engine later.

[adrianfromthecastle]

^ i stand corrected

[Bumnah]

if there is an issue with an exhaust not fitting. may be effected by where the downpipe sits for the sr vs the header on a ka. even if it isn't exactly the same you'll need to modify the exhaust moving it around and extending the exhaust a few inches shouldn't be a problem. may just cost you a few bucks at the exhaust shop.

i say it'll bolt up like normal though.

[jr_ss]

There shouldn't be a need to get an exhaust extended. From the catalytic converter back is the same whether it be on the ca/sr/ka. Just like someone stated, chassis specific not engine specific. Just make sure you have the right dp for your engine and it'll bolt right up to the cat and so shall the cat-back exhaust..

BTW, awesome choice on exhaust. I have Fujitsubo Regarisu R (Legalis R), quiet but still an aggressive tone.