SPL custom FN01R-C 17x9 +20 in 4x114 bolt pattern for 240SX

[Dammitboy]

Anyone have this particular set from SPL? Likes - Dislikes? Opinions please, other then them being "played out".

Thanks,

Kevin

[yokota180sx]

you putting on the front?on an s13/14?

what other mods do you have?

You gotta give more information

[240DRFT]

i think its a good set up. pretty good sizes and somewhat lightweigt. u can see the pics on spls site and naed240sx has them. id seriously consider getting them if i wasnt going 5 lug

[yokota180sx]

s long as you don tmind rolling the rear a little bit, and adding some camber on a stock front, relocating your hrness, and banging your fenderwell

it will fit fine.

[Dammitboy]

you putting on the front?on an s13/14?

what other mods do you have?

You gotta give more information

OOops, sorry. 92' S13 coupe. Stock struts with Eibach springs.

[Dammitboy]

relocating your hrness, and banging your fenderwell

it will fit fine.

Can you elaborate on this part please?

Thanks.

[240DRFT]

the harness goes through the drivers side wheel well, relocating it through the engine bay eliminates the problem of the wheel rubbing against it if youre low. and i think when he says fenderwell he might mean the seam thing that you can just hit with a hammer

[yokota180sx]

nvrmind, py no attention

they will fit fine wiht your current setup.

your not low enough to worry about any of it