Solid Transmission mount, what have you guys made? S13 Manual

[drifterjay]

Alright, the rubber transmission bushing (mount) is completely separated on my car. Tomorrow night I need to commute back to work which is two hours away. Therefore I cannot pick one up at FR sport since they are closed completely on Sunday. I have a lot of angle iron, various pieces of steel, a mig welder, and a stick welder, as well as all the proper cutting tools to fabricate one. Before I reinvent the wheel tomorrow, has anyone else here made one from scratch? That way I have an idea of where to start? Thanx!

-Jared

[Ligerzero]

i used a solid piece of round stock aluminum and just cut it ot the right height and drilled out the center, put a rubber or poly bushing between the motor and the mount. One long bolt and you're good to go