Short Ram intake video and Problem

[Pathfinder3.5]

So i got my Maf adapter in the mail today. Of course the fasteners fell out during shipping but I got some from work. No big deal. I got everything slapped together and took it for a 'spirited' drive. The intake noise is impressive. Sounds meaner and the throttle response is much better. I ran into a small problem after the video(posted below). The check engine light came on. I haven't gotten around to scanning it but the one thing i didnt relocate was the Intake air temp sensor. I just left the resonator and sensor where they were. Does that sound like the problem? It came on right after a full throttle run.
http://www.youtube.com/watch?v=kYAIvBd_ekw

Its neat hearing the Valves inside the intake opening around 5,000Rpm
Thanks!

[Chris.m]

When I removed my intake resonator, I just zap-strapped the air temp sensor to what ever was closest and everything has been fine.

I don't have a short ram though.

Try pulling a code and we'll go from there

[Pathfinder3.5]

Will do hopefully tomorrow. My gas cap has been falling apart for a few months now so it could just be another temporary evap code. Gotta order a new cap asap. I will update when I figure out what code it is.

[esy]

reset the ECU and see if that solves it. the IAT sensor shouldn't be the problem. it could be, but i doubt it.

[Pathfinder3.5]

reset the ECU and see if that solves it. the IAT sensor shouldn't be the problem. it could be, but i doubt it.

Thats what i figured. No matter what there should be some air travelling through the chamber. Ill try my best to pull the codes tomorrow. It is my Birthday but ill try my darn best!

[Pathfinder3.5]

Ok so I pulled the Code and its a P0138 02 Circuit High Voltage(Bank 1, Sensor 2). Doesn't sound related to the Intake at all...Just a fluke.