Series II RB25DET in R32 GTS-T???

[CarolinaR32]

Like the title says im wanting to put an RB25 in my R32 but I have some questions concerning the swap.1) Driveshaft which one to use or do I need one made?2) Wiring harness??? Ive heard I need to cut and splice the dash harness, wire in VVT, etc...If someone can shed some light on this subject I would greatly appreciate it.

[Joe]

im ALMOST positive you are going to need a custom driveshaft. i know for a fact the R32 shaft wont fit in a RB25 transmission but am not sure if the R33 shaft bolts to a R32 rear end and if the length is correct

yes you are going to need to rewire parts of the dash harness, its not as bad as it sounds.

VVT is self contained in the RB25 engine harness you dont need to worry about it.

[sean8564]

Very easy swap we Did one In A R32 GTST you will need a Driveshaft but that is it really the wiring is super easy just likea Sr in a 240 swap. trust me the Swap is well worth it over the RB20 the car will pull harder as well it will just feel more solid of a ride than the Rb20 dose.

[CarolinaR32]

Can one of you email me and elaborate a little more on the wiring?

[Dnight07]

any one have an extra harness series 2 for the rb25det..?

[BigC_1988]

Do you happen to have the R32 dash plug pinouts??? I'm also swapping my RB20 with a RB25det S2