seperate transmission from bellhousing? need to know by tomorrow!

[jt15833]

spent 4 hours in the junkyard today removing a transmission from a RWD 200sx because I need the bellhousing for a swap. The motor is a ca20e. I got the transmission out and there is the bellhousing, then a 1 inch block of metal then the transmission. They are seperated and i broke the seal bond and i can wiggle them, I can get about an inch between the 1inch block and bellhousing and maybe 2.5 inches gap between the transmission and 1inch block. I just cant get the three seperated, i don't think they just pull apart. Anyone have any idea??

thanks

[KFL]

I'm a bit confused.. But if you removed the transmission and just want the bellhousing, and want to remove the internals. There is the cover you have to remove using a slide hammer, you use the bolt/holes on that cover.

[jt15833]

are you talking about the pentagon shaped cover inside the bellhousing around the spline shaft that goes into the clutch? I got the cover off, I need to touch the bearings and shaft inside??

[slow s13]

just remove the 2 big circle clips on the two bearings and start pullin it will come off then.