sedan front door speakers

[gilo]

im puttin after market speakers in my car, and im pwoering them with a 4ch amp. i have my wires run into the back doors, how do i get them into the front door???its plastic on the front doors and, rubber on the rear door.please help!!!

[pfarmer]

im puttin after market speakers in my car, and im pwoering them with a 4ch amp. i have my wires run into the back doors, how do i get them into the front door???its plastic on the front doors and, rubber on the rear door.please help!!!

I don't have an 04 so can't reply to what is there. However on one vehicle that I upgraded the speaker wires to I created an extra path. On it the stock wiring to the door for everything is basically molded into a piece of plastic. Would have been a royal pain to replace.

There are many flexible boots available that can be used from several of the hardware and electrical outlet stores. If this sounds similar I would go this route to avoid problems with the stock wiring for other functions such as mirrors, doors, etc. unless you are prepared to work on them all.

Perry

[gmacgs19]

ou could always drill a set of holes get "3/8" smurf tube from a home depot or lowes and get a few bushings like when you penetrate a firewall with a power cable for an amplifier... just a suggestion

[pfarmer]

ou could always drill a set of holes get "3/8" smurf tube from a home depot or lowes and get a few bushings like when you penetrate a firewall with a power cable for an amplifier... just a suggestion

And basically what I was speaking about. You can also use the rubber boots used on various types of cables. There are a lot of options it is just a matter of finding the one that works best for a particular vehicle. There are lots of kits available for example to run the wires for power window retrofits on an old car.

Perry
Modified by pfarmer at 2:21 AM 2/25/2009

[g35sedanlover]

Are u running this off the factory head unit? If so, tell me about what you are running. I am thinking about doing the same

[gilo]

yea i'm running the factory radio, i ended up drilling the holes, because infiniti used hard plastic connectors in the front doors instead of running the wires thru a rubber sleeve and gromet like the back doors.