safc setting

For the RWD SR20DET cars! Sponsored by Wiring Specialties.
Post Reply
scottsnissan
Posts: 393
Joined: Wed Sep 15, 2004 1:06 pm
Car: 1995 240 sx se
Contact:
Contact scottsnissan

Post

Jus installed it and was playing.I was wonmder what some one else used as setting on a stock sr swap.

Heres my set up stock everything down to the side mount.execpt the air flow meter no longer sr but the us equal.

Top
scottsnissan
Posts: 393
Joined: Wed Sep 15, 2004 1:06 pm
Car: 1995 240 sx se
Contact:
Contact scottsnissan

Post

Srry all i know of the 6/6 but are there any others i should adjust or no.
Top
User avatar
Jesse SR20
Posts: 280
Joined: Fri Jun 25, 2004 8:37 pm
Car: 1990 S13 fastback
Location: Your mom's house.

Post

It's been said before, but I'll say it again.

There are no "end all - be all" settings for an safc. Some one with the exact same setup as you could require different settings based on so many variables.

Get a wide band O2, or go to a wide band equipped dyno facility, and tune it. Period.

As for the mafs in-out settings, I'm not 100% sure about those. I believe a stock SR mafs would require 2 in 2 out. But I know the actual voltage read by the ecu is a bit more than 2 volts.

Anyone else care to add ?
Top
Post Reply

Return to “SR20DET Forum (rear-drive)”

Search for Nissan stuff on ebay!
Find Your Forum!

 

NICOclub's Nissan forums and Infiniti forums and all affiliated sites are the property of HDS Holdings, Inc.
They are independent publications and are not affiliated with or endorsed by Nissan or Infiniti.

Information Copyright © 2000-2026 by NICOclub, all rights reserved. Material may not be copied or reprinted without written permission.

Privacy Policy