S14 SR20 Fmic +Bov Install Help!!

[BravoS14]

I have a stock s14 SR I just bought a cxracing fmic & Hks bov . So I installed everything so now I have a few Q's on were the 4 hoses go(plug or hook up) under the TB.

Pink is to BOV (1)

Right of the pink ?(2)

Above (2) Is Plugged Yellow dot(3)

Right of (3) ? is (4)

(5) is the copper one with no hose .



Over view

On the hotpipe side I (T) off the BOV ane the Actuator Because I dont have a nipple for the the Actuator tube

Bottom of Cold Pipe

The Main reason I am asking is because I hooked everything up how I thought and When I started my car it idled fine when COLD but as soon as it got WARM the RPM just dropped to around 100 Rpm . So when i rev it up it just dies.

Only Engine Mods: Fmic,Bov,HKS F-Con V Pro
Modified by BravoS14 at 9:10 PM 2/28/2010

[BravoS14]

help major vacuum problem . I just ordered a hks recirculation fitting

[xThe_Onex]

i just finished installing the same intercooler kit on my s13 sr. i ran into the same problems too except when i gave it some gas it would bog down and made my car run super rich. i recirculated the bov and made a boost source from the hotpipe for the wastegate. all my problems went away.

[BravoS14]

FIXED !!!!!! I had my wastegate T of with the bov (Bad) so I read from here on nico!! and ran the wastegate to the small nipple on the cold pipe . #2 I ran #5(Copper Nipple) to the bigger nipple under the cold pipe. Solved I love the Ricer sound !!