S13 transmission into S14 (CAS sensor a problem?)

[Dano]

I asked a few ppl, but haven't gotten a definate answer, The S14 transmissions have a crank angle sensor, the S13s dont... i have an S13 transmission to put in my S14...is this going to pose a problem in my S14...or can i still use the S13 (DOHC) transmission? its an ODBI '95 and i also am gonna be using the OBDI 95 manual ECU...

thanks in advance!

-Dan

[BIGT94z]

did u figure this out yet dan? i also have the obd1 s13 transmission however im running everything else obd2 so obviusly i have a cel of cas...the only problem u get from doing this is of course the annoying cel

[180fan]

you can use the s13 transmission but you'll need a resistor (get a multimeter and measure out the resistance across the old sensor) and you'll be able to fool the ecu into thinking everything is good to go.

[BIGT94z]

i thought of doing something like that but have never fooled with it...i might this winter when im bored!! i hate having a cel

[nightkid86]

you could drill a hole in the bellhousing and mount the sensor. It doesn't engage into anything, the sensor just sits above the magnetic flywheel.