yea i just put it on just to start it up, i am making some new one's, oh yea the sway bar is on, and it has plenty of room.450SX! wrote:like the passenger side header. do you have room for a sway bar with the crossover being down by the balancer.
2 1/2 crossover pipe, to 3" Y to turbo and 3" downpipe450SX! wrote:
what size exhaust are you going to run off the turbo?
thats normal, some bov's are sinsitive and any vac at all can pull them open. I may not have a problem with that, i have very low vac on my motor.450SX! wrote:my bov only opens when i am at least close to 0 " vacuum at least that i can hear.
curious about bov opening when not under boost.i once saw a camaro with 2 gt45's rear mounted and the bov would open and close during the idle. seemed wrong but I am a noob.
lol240cp wrote:Is it me or is there a very weird looking person standing behind the driver door on the top pic.
Sorry had to ask
240cp wrote:Is it me or is there a very weird looking person standing behind the driver door on the top pic.
Sorry had to ask
im just going to be running a 4" cowl, i measured everything up and it should fit ok.450SX! wrote:what are you going to do for a hood scoop? also a design issue with building the cold pipe from intercooler to the throttle body is what kind of scoop are you using and will it fit under it. just a little heads up if you have not crossed that bridge yet. looks good ,
i thought that if i ran megasquirt it wouldnt be so pricey, i was wrong but it was not to bad450SX! wrote:I'm jealous ,wanted the fuel injection too but could not squeeze into my budget.
yea it will work, i did not remove the whole harness only the engine harness. their are only a couple of wire's you need to tap into to make it work for you. eccs and fuel pump, the ka lower harness will work minus the transmissinon speed sensor etc.Mudvayne wrote: matafied did u take the whole wireharness off. im worryed about my lights windows radio ect and i want to use the stock ignition was thinking of use the wires from stock starter will it work
Modified by rsagen at 2:33 PM 10/16/2009s13junkie wrote:did you keep the measurements for the oil pan? I plan to go in the same direction with a 383. What will yo do for headers?
man i still got mad love for my RB'sUSMCgetsome wrote:matafield you traitor! i gotta go take a shower now i feel so dirty look at those v-8 pics!