s13 89 ka24de swap

ONLY for ADVANCED technical discussion about the 240sx!
destroyyourmind
Posts: 557
Joined: Mon Nov 19, 2007 4:54 pm
Car: 89 240sx hatch ka24de. 91 240sx hatch.

Post

Ive done everything possible to get spark minus distributor, wiring harness, went through 3 ign coils sohc ign coil repined then two dohc, new ngk spark plugs fresh oil and coolant, replaced ALL fuses checked all grounds all it does is turn over and wont spark, is there any way to tell if my distributor is bad?


User avatar
da240
Posts: 85
Joined: Wed Aug 08, 2007 8:24 am
Car: 98 Coupe

Post

well are you getting any spark at all? Recommend to pull out one of the spark plug wires and hold it against the block, turn car over should get spark. if you do get a spark, your fuel pump might not be priming. If you dont get a spark then replace distributor. Thats my guess, good luck


Kraelic
Posts: 104
Joined: Mon Sep 04, 2006 1:05 pm
Car: 89 240sx

Post

Mine done the same it would crank and not run, I forgot to attach the grounds from the fuel injectors to the head by the firewall on the exhaust side. I thought it was timing or spark until I saw these grounds still loose. one bolt later and it fired up.

destroyyourmind
Posts: 557
Joined: Mon Nov 19, 2007 4:54 pm
Car: 89 240sx hatch ka24de. 91 240sx hatch.

Post

haha tried the spark idea thanks though, and I have all the grounds hooked up as far as I know there is one beside the ground that goes to the starter that I dont know where it goes could that be it?

destroyyourmind
Posts: 557
Joined: Mon Nov 19, 2007 4:54 pm
Car: 89 240sx hatch ka24de. 91 240sx hatch.

Post

bump

destroyyourmind
Posts: 557
Joined: Mon Nov 19, 2007 4:54 pm
Car: 89 240sx hatch ka24de. 91 240sx hatch.

Post

bump for being without a dd


Return to “240SX Technical Forum”