replacing abs module with adj prop valve

[s13sr20chris]

i was thinking of ditching the abs module and installing an adj proportioning valve in its place. the abs module is big, nonfunctional, and overall annoying to work around. anyone have any thoughts or ideas about this? it would be some serious racecar looking stuff eh?

[C-Kwik]

Why is it non-funtional? I would take ABS over a proportioning valve.

[Dori Dori]

S13 abs sucked imho. I disabled it but have yet to remove it. When I do, I plan on replacing the MC.

[s13sr20chris]

non func because half of the wheel speed sensors(no 2/3 actually) are inop/mia, i dont feel like wiring it up, the abs module is rusty and funkdified, and finally adj prop is really racecar. plus then i can run any calipers i want front and rear without wierd oversteer/understeer on brake. that is unless i want that. it also makes it hard to mess with the wiring harness in the car. i just want that abs gone.thanks for replying. i really like to discuss this kind of stuff before i do it.