repining sr ecu harness

[CaEric]

well my coupe with a blacktop had a j4 ecu....so now i have an enpthy ecu...so now i have to revire my ecu.....who do i get the pin out the connecter!!?should i needa new pin were can i get ti from....and what type ?

[DuckyD]

Why would you need to rewire with Enthalpy?

[CaEric]

i had to go back to stock and it was wire for type x pfc !!!! so i used a j4 ecu ... i just need to know who to take a pin out the blue connector

[MrSoutherland]

Pull the plastic hinge pieces back. Then get a safetly pin to stick in the hole. You will need to get a light in there so you can see the tab that you bend back and pull the pin out. I had a J4 as well.

[Justin35ll]

it can be a pita, but after you do 1 or 2 it becomes easier just pull back those tabs on the side then stick somethin down in there and pry them up or pull them out