Repacking Wheel Bearings

[e2xx33]

Hey Guys,

I just had a few questions regarding repacking the front wheel bearings. The FSM calls out that the 2 o-rings on the drive flange, grease seal, wheel hub cap, and snap ring needs to be replaced when doing a repack job. I can understand the 2 o-rings and grease seal, but is it really necessary to replace the snap ring and hub cap?

thanks

[Pwnin O'Brien]

I only see where it says to replace the hub cap (which is not necessary unless you beat the hell out of the original one to get it off). It says to grease the drive flange o-rings before replacement. You also would only need to replace the grease seal if you beat the hell out of that trying to get it out.

EDIT: I see what you're referencing, I think (the CV diagram?). Don't follow that diagram, you want to follow the directions more-so than the diagram. The diagram is really meant for a CV overhaul. Of course you want to use your better judgment on whether to replace parts or not. If the part looks worn or damaged you should replace it.
Modified by Pwnin O'Brien at 1:53 PM 3/19/2010

[e2xx33]

thanks pwnin