removing ka24de wiring harness

Post by **ralphsdiorama** » Tue Jul 25, 2006 2:27 pm

I just got my ka24de out and I'm trying to figure out how to get the ecu wiring through the firewall. Do I have to pull the dash and heater box out? If anyone could explain how that would be great. Thanks

Post by **S13240** » Tue Jul 25, 2006 2:42 pm

Pull off the rubber grommet off the firewall in the engine bay. Of course you'd have to unscrew the ecu plug off the ecu and unplug the dash plug that goes up to the dash board. Then just pull the harness out from the engine bay.

Post by **ralphsdiorama** » Tue Jul 25, 2006 3:53 pm

Do I have to remove my ABS to do this?

Post by **fireheadmt** » Tue Jul 25, 2006 4:31 pm

ralphsdiorama wrote:Do I have to remove my ABS to do this?

maybe but probably not, it should be attached or anything, as long as you have it unplugged. just be careful pulling it through the hole where the grommet was, feed it through slowly. maybe get someone on the inside of the car to guide the ecu plug up through

removing ka24de wiring harness

removing ka24de wiring harness

Re: (ralphsdiorama)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums