Removal of Dent just above wheel well

[svard75]

Wondering if anyone has any experience with dent removal. I have a slight dent that is just above the drivers rear wheel well. I would typically pop it out again but I noticed that there is a part of the body that comes out from near the bottom of the wheel well towards the body. Almost like a double layer so I can't get up there to pop it out.

Does anyone know of any techniques they could share? I already tried to get into that cavity by removing the rear door latch but there's no hole there just for the two screws.

I thought about the trunk but before I take the time to remove all the lining has anyone done this and see if that part is accessible?

CHEERS!

[szh]

Might it be worth having a professional fix it? Check out http://www.dentpro.com/ for more info on one resource.

BTW, I am not saying that you could not fix it yourself ... just that the cost may be low enough for a simple dent to have somebody else do the work properly and thoroughly.

Z

[svard75]

I called a few local PDR shops but they are all either too busy or inconvenient. I want someone to come to me to fix it.

Anyway it's right on the wheel well crease so I'm almost 99% certain they'll just look at it and say sorry can't.

I would rather just try myself first then if it doesn't work take it in.

Do we have instructions on removing the trunk liner properly?

[Mach45]

You may want to consider the Ding King. It's a do-it-yourself dent kit for under $20. You can pick one up at your local auto parts store. I tried it on the wife's Murano and was able to pull most of her dent out out. It was originally the size of a half dollar, but because it was along the door crease I wasn't able to get it all out (about the size of a nickle now). Check out the reviews on Amazon and you may want to try it out. Good luck!