rebuild but no firing?

[1lowhatch]

I just recently rebuilt my motor and now it turns over but it wont fire it sputters like it wants to but nothing. Would that have anything to do with my cam positioning sensor?

[240_SeX]

Do you have spark? No fire means no spark but if its sputtering you have to have spark. Also did you paint anything? if so make sure all grounds are clean and have good connection. hows the fuel? any pressure? what did you do in the rebuild? is it tunned? cams? This is all important info

[1lowhatch]

well its tuned yeah but the only thing i changed was the crankshaft, main and rod bearings it ran fine before that and i didnt change nothing it ran fine but then i got a rod knock so i put it all back together the same with the exception of the bearings and crank the block is in time i just didnt know how to mess with the position sensor

[240_SeX]

are you sure you set your timing right? you should not have to adjust the CAS if you ididnrt change anything from your previous setup

[1lowhatch]

yeah i set my crank to the first line on the pulley then put my cams at 10 and 12 o clock then spun the crankshaft around until the timing chain matched all the mating marks

[240_SeX]

that may be right, your description is a little vauge. re-time it buy the FSM procedure

[1lowhatch]

alright ill try that thanks