RB26DETT Oil Filter "Connector Bolt"

[Kwame@Z1]

Anyone know the specs or dimensions of the oil filter "connector bolt" on the RB26DETT, specifically one from a GTR R32.

I am trying to figure out if it is the same bolt used on a VQ35DE.

Thanks in advance.

[240z4u]

Is your car painted chameleon(sp?). And were you at SEZ last year?

If your more specific about which "bolt" your talking about I can measure my RB25DET one for you this week.

Evan

Can you show a picture?

[Kwame@Z1]

No and No.

I don't have a picture, but its the bolt that you screw the oil filter onto.

[Sil240]

Not sure about the RB26 but the RB20 and 25 use the same Oil filter as the KA.

[Kwame@Z1]

Bump!

[74260zt]

You need Nissan part # 15213-21001

to replace this part>>

[Kwame@Z1]

Thanks.

When you say I need it to replace "this part," is the part you posted in that photo the bolt from a VQ35DE or an RB26?

Thanks again in advance.

[74260zt]

Thanks.

When you say I need it to replace "this part," is the part you posted in that photo the bolt from a VQ35DE or an RB26?

Thanks again in advance.

RB26

Here is one on ebay>> http://cgi.ebay.com/ebaymotors...wItem

[Kwame@Z1]

RB26

Here is one on ebay>> http://cgi.ebay.com/ebaymotors...wItem

Thanks.

I hope this works.

FYI. The reason for my initial question. I ordered an HKS oil cooler kit for my 350z however the HKS oil cooler kit that arrived is for an R32 GTR. Unfortunately, the oil cooler was special order as is such there are no returns. The kit comes with an oil filter relocation bracket and a sandwich plate that mounts to the block and screws onto the oil filter stud. The sandwich plate supplied with my oil cooler kit is designed to fit an R32 GTR filter stud. I just want to make sure its going to fit, hence why I was trying to see if the VQ35DE and the RB26DETT run the same oil filter stud.

[Coolwhip]

Joel thanks for the link!